Toyota Previa front end disassemebly.

This was something that I wanted to go through, but was forced to on my end.

I was behind someone at an off ramp turning left. It was green and the lady infront of me started to go, so I started to go.

Then this guy blew ran his red light and almost slammed into the lady in front of me had she not slammed on her brakes.

Subsequently, I slammed on my brakes and bumper her.

SUCKED. We caught up with the guy down the street and I confronted him. I almost punched his dumb ass.

Anyways, I was forced to hit the junkyard for parts.

It is a process to get to the middle piece under the headlights and above the bumper.

So this was step by step deal and took me a couple hours.

https://youtu.be/pC0LhZLk3pE?list=PL5q_8kLVTuqLa8ICIVQa1E_sfirAHnz0y

I put the everything back together. The front headlight that was affected is about 2mm pushed back. Once I get in my autobody class in the fall, I'll probably put in on the frame straightener and pull it.

Comments

EGR system Clean out and Code P0401

EGR system clean and Code P0401 This is another MUST DO on the previas, especially if you are having issues and code P0401 being thrown. P0401 is "Exhaust Gas Recirculation flow insufficient detected". Parts: - EGR intake gasket - 25628-76010 - this is on the far right side next to the exhaust. - EGR valve gasket - 25627-76010 - used for the EGR valve to the intake manifold. -Air inlet duct gasket - 22273-76010 - this is where the air goes into the intake manifold and where the EGR port gets plugged. 1 container of coolant I did buy a set of crow's feet and Universal joints for the Exhaust pipe. I followed Zenseeker's photo's on every single detail. If you haven't visit his website (http://zenseeker.net/Previa/PreviaMaintenance.htm), it is a treasure trove of information!!! Zenseeker gets the credit and this would have been impossible for me to do without those pictures! **The pictures are located at the bottom of this po...

I GOT A COOLBOX!!!!!!!!!!!!!!

I found out that the previa had a "cool box", which is like tiny fridge under the dash in the middle, from Toyotavantech. I have seen them only in photos and in Canadian spec previas (unsure if they were in US spec). Even our owner's manual has some mention of them. Often times, I would look at CL in Vancouver BC in hopes someone wants to sell or part a van with it. Now, I've seen a few different versions, in which I don't have the ones that are pictured below. (note, these cool box images were found on the internet). A slanted shape one This is a cool and hot box, 3 buttons on top ------------------------------------------------------------- I've kinda looked at the cool box as a Holy Grail. 9/12/15, Saturday. After volunteering my morning at the farmer's market making boxes and putting fruits and vegetables for low income families (Phat Beets Produce!) here in Oakland, I went to go fill up gas in ...

Comparison of the Estima (ACR), Estima Aeras (TCR) and Estima Emina..

I'm here in Vancouver BC and stopped by a shop called Velocity Cars. It is a car lot that sells some imported Japanese vehicles. Import laws are different in Canada. These are all legal. They had 5 Estimas. 2 ACR Estimas, 2 TCR Estimas (like the US previa) and One Estima Emina. Looked at all of them to see their differences. They are all 8 seaters as well. First I looked at the Estimas (TCR) that were the same body as the US Previa. Besides the awesome upgrades, one was lowered, but they are the kouki versions, so newer headlights, tail lights and one had the newer Aeras roof rack. Both were AWD. The side mirrors' top were extended like a sun guard. Obvious difference in the outside, but the inside, pretty much the same. There were some small differences. 1. Rear A/C had more buttons for adjusting flow. 2. The lower tray. US previas had a tray (some didn't). Of course some Canadian models had the cool box set up. The Estima has a tray, but it is raised. The to...

About my Previa and Sienna

Search This Blog